Flight tests and flight data analysis - teaching aerospace engineering students
Article Sidebar
Main Article Content
Abstract
The ability to carry out in-flight tests and to analyse the flight data registered is, in the case of aerospace engineering students, a vital aspect of education. Since aircraft flight tests are very expensive, frequently the funds allocated to them in the process of education are insufficient. The aim of this article is to present a relatively low-cost method of training students to carry out flight tests and to analyse flight data. The method relies on three consecutive steps. At first, simulation tests relying on the mathematical model of an aircraft are carried out. During these simulations, students analyse aircraft behaviour. Next, flight data registered during previously held in-flight tests are analysed. Finally, flight tests are performed by students. As a result, having mastered the ability to analyse real flight data, the students trained will become high-class specialists being able to conduct flight tests and analyse flight data.
Downloads
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
References
Boden F. (ED) (2013) Handbook of Advanced In-Flight Measurement Techniques Books of Demand Norderstedt, p. 160.
Rzucidło P., Kopecki G., Kucaba-Piętal A., Smusz R., Szewczyk M., Szumski M., K. de Groot (2015) Data acquisition system for PW-6U in flight boundary layer mapping, Aircraft Engineering and Aerospace Technology DOI: 10.1108/AEAT-12-2014-0215.R1
Kopecki, G. Rzucidło P. (2015) Integration of optical measurement methods with flight parameters measurement, Measurement Science and Technology (accepted for publication)
Mystkowski A. (2013) Robust Optimal Control of MAV Based on Linear-Time Varying Decoupled Model Dynamics, Solid State Phenomena, Vol. 198 Pages: 571-576
Kopecki G., Rogalski T. (2014) Aircraft Attitude Calculation with the Use of Aerodynamic Flight Data as Correction Signals, Aerospace Science and Technology 32 (2014), pp. 267-273
Kopecki G., Rzucidło P., (2006) Problems of Monitoring in the Fly-by-Wire System for Small Aircraft, AIAA-2006-6340 Paper, AIAA Guidance, Navigation, and Control Conference and Exhibit, Keystone, Colorado.
Spiegel, P. Kriegel M., Dambeck, J. et al (2015) Slant Range Analysis and
Compensation of Radar Altimeter Flight Test Data PROCEEDINGS OF THE 2015 INTERNATIONAL TECHNICAL MEETING OF THE INSTITUTE OF NAVIGATION Pages: 223-233
Witkowski, R. (2011) Where are you going, the black box? Zeszyty Naukowe Politechniki Rzeszowskiej. Mechanika z. 83(279), nr 2 (in Polish)
Basmadji F., Gruszecki J., Kordos D., Rzucidło P. (2012) Development of ground station for a terrain observer - Hardware in the loop simulations AIAA Modeling and Simulation Technologies Conference DOI: 10.2514/6.2012-4629
Tomczyk, A. (2010). The flying laboratory for aeronautics students' education. Aircraft Engineering and Aerospace Technology 09/2010; 82(5):320-330. DOI:10.1108/00022661011092965